Slit Coil & Strip
Coil slit to the width your line runs on, rather than the width the mill happened to roll. HR, CR and GI, rewound and banded, so a pipe mill or roll former is not paying for steel it will only trim away.
Slit Coil & Strip: sizes and grades we hold
- Input coil
- HR, CR and GI
- Thickness
- 0.4 mm to 6 mm
- Strip width
- From 20 mm upward
- Tolerance
- Confirmed against your line
- Supplied as
- Rewound coil, banded
- Turnaround
- Quoted with the material
Uses for Slitting on Demand
- Pipe and tube mills
- Roll formed profiles and purlins
- Press shop blanks
- Strapping and banding
- Shutter and profile manufacture
Slitting is priced per ton on top of the coil, and it pays for itself the moment your scrap rate drops. Send the strip width and the tolerance your line needs.
Tell us the coil weight your machine can take. There is no point slitting a full coil if your decoiler tops out well below it.
From enquiry to delivery
Four steps, no forms and no account to open.
Send the size
WhatsApp the size, grade and tonnage. A photo of the drawing or the old challan works just as well.
Get the rate
A per-ton or per-piece figure the same day, with freight quoted separately so you can see both.
Confirm and weigh
Material is pulled, tagged and crossed over the weighbridge. The weight on the bridge is the weight on the challan.
Loaded and gone
Karachi same or next day where stock allows. Up-country dispatch to Lahore, Multan, Islamabad and beyond.
Before you order
Most sizes on this page are held. Where something is not, we source it from the mill or the market and tell you the day it lands rather than promising same-day and going quiet.
There is no formal minimum. We sell single lengths and full trailers, though the rate improves with tonnage and freight makes very small out-of-city orders expensive.
Yes, on most sections. Send the cutting list with the enquiry and the cut lengths are quoted with the material rather than added as a surprise afterwards.
WhatsApp the size, grade and tonnage to 0334 8398777. You will have a workable number the same day, and a firm one once we confirm what is on the floor.
Slitting on Demand rate in Karachi today
Message the size, grade and tonnage and you will have a rate back the same day. Rates move with the mill and the dollar, so we confirm on the day rather than publish a figure that goes stale by the afternoon.